![]() The selector MUST be welded in semi though, and when you cut your tube the disconnector slot MUST be only wide enough for the disconnector to stick up into the tube, and not travel to the FA position. This notch prevents the disconnector from being able to move via selector switch even if the weld on the selector switch wasent in place. The barrel will be the hard/expensive part to get.Īs far as semi-trigger mods, basically the selector switch is just welded in the semi-auto mode, and there is a corresponding notch in the indy ord receiver where the disconnect or stick up into the receiver tube. A bit much on shipping, but fast service. kit, particularly the modifications to the trigger assembly? in order to finish the STEN MK2.5 front end it looks like I'll need: Barrel, Mag Housing, HandGuard and Barrel Nut? Anything else?Īlso, is there a chance we could see more internal pictures of the I.O. I may end up just buying a few of the new MK2 parts from Indy. I've found the MK2 kits near impossible to come by at a reasonable price, but the MK3 kits have not been too bad. ![]() I've ordered a few STEN kits, and am going to try my hand at a similar MK2 pistol, and MK3 rifle. I've always liked pistol caliber carbines (I've been obsessed with the MP5 series for a long time), and I really enjoy the interesting history behind each of these guns. I would like you to know that this thread alone sent me into an "old school" SMG craze. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |